Author Topic: Smokin shad 3.75  (Read 430 times)

Offline BullardsTackle

  • Minnow
  • *
  • Posts: 1
Smokin shad 3.75
« on: 08/21/17 11:58 UTC »
Are you able to use a dual injector with this mold to get a top/bottom laminate?

Online Mike J

  • Lunker
  • *****
  • Posts: 1403
Re: Smokin shad 3.75
« Reply #1 on: 08/21/17 12:10 UTC »
I don't have that mold but as a general rule any single cavity mold can be laminated with a duel injector.

Online WALLEYE WACKER

  • Lunker
  • *****
  • Posts: 2266
Re: Smokin shad 3.75
« Reply #2 on: 08/23/17 10:25 UTC »
Most paddle tail bait's are side inject and can't be twin injected unless there is the option for a individual top inject. There are some molds that are side inject that an be twin injected swim shad, carrot, twister, craw's, stick bait, tubes just too name a few. I don't think the 3.75 smokin shad is laid out that way.

Online Mike J

  • Lunker
  • *****
  • Posts: 1403
Re: Smokin shad 3.75
« Reply #3 on: 08/23/17 11:09 UTC »
But since it's a single cavity it will work. Just rotate the block 90 so it's parral to the mold. It's layed out same as the ripper single cavity and I can duel inject that mold just fine so I don't see why the smoking shad wouldn't work.

Offline Rich

  • Yearling
  • **
  • Posts: 26
Re: Smokin shad 3.75
« Reply #4 on: 08/23/17 12:54 UTC »
This is shot with a twin injector.  (Light Blue and Pearl)
« Last Edit: 08/23/17 12:56 UTC by Rich »

Online ctom

  • Lunker
  • *****
  • Posts: 7347
Re: Smokin shad 3.75
« Reply #5 on: 08/23/17 12:59 UTC »
Welcome to the Do-It forums Bullardstackle!