General > General Discussion
Freedom Fry
(1/1)
RufNec:
Is the Freedom Fry mold still a hinged mold or is it now a 2 piece?
ctom:
The Freedom Fry is an open pour mold....one side. Open pour = hand pour. An injector can be used to lay the plastic in the mold and may be a better option for some people who have issues with hand pouring.
RufNec:
The picture in the store shows it to be a 4 cavity injected mold with hinges.
ctom:
Ah Ha! Right church, wrong pew.
The injectable version is hinged....or so indicates the picture.
efishnc:
My understanding is only the smaller molds are not hinged (although some larger ones that were very early in the lineup were not as well, but you should not see this unless you are buying old molds from another source)... I had the FF a few years back and it was hinged.
Navigation
[0] Message Index
Go to full version