Custom Baits - Forum

Jigs, Spinnerbaits and Sinkers => Bass Jigs => Topic started by: Stilyakin on 01/30/20 15:43 UTC

Title: Midwest mold for elaztech
Post by: Stilyakin on 01/30/20 15:43 UTC

Hello everyone! Just joined yesterday. Thinking about getting a Midwest finese mold and plan to use zman.  Seems like the holder for the plastic is a bear to get over the hook. Anyone have any ideas?  I remember the holder for mister twister keeper worm hooks would  probably work but cannot find any of them or anything like that.

Title: Re: Midwest mold for elaztech
Post by: 21xdc on 01/30/20 15:55 UTC

You might try to modify tour mold for these instead of the wire keeper.   http://moanerhooks.com/product/stickr-pins/

(http://moanerhooks.com/mhs/wp-content/uploads/2014/08/StickrPins800-800e.jpg)

Title: Re: Midwest mold for elaztech
Post by: Stilyakin on 01/30/20 16:14 UTC

21xdc that's exactly what I was thinking of. Thanks!

Title: Re: Midwest mold for elaztech
Post by: ctom on 01/30/20 16:17 UTC

Apparently ordering has been disabled.

Title: Re: Midwest mold for elaztech
Post by: Stilyakin on 01/30/20 19:23 UTC

Right idea but unable to buy

Title: Re: Midwest mold for elaztech
Post by: 21xdc on 01/30/20 19:32 UTC

Did you call the tele number?   610-333-7688

"Have Questions or Problems Ordering   You can call: 610-333-7688 or use our contact form to send us a message"

Title: Re: Midwest mold for elaztech
Post by: WALLEYE WACKER on 01/30/20 22:49 UTC

Welcome to the family stilyakin I think 21xdc has you covered.