Jigs, Spinnerbaits and Sinkers > Skirts

DI-IT skirt tool Item 7469

(1/2) > >>

housebg:
Hello I can not figure out how to make it work and can tell or send viedo  Billy

Apdriver:
Skirts come in tabs with the ends uncut. So the first thing to do is slide a skirt band over the pointy end and roll it past where the tool separates. Then hook a couple of skirt tabs by the end where all the cut pieces are joined and pull them into the barrel of that tool and partially out the other end. Now you roll that band you preloaded onto the skirt. Pull the skirt out, cut the ends off and you have a skirt.

21xdc:
Google is your friend...
https://www.youtube.com/watch?v=L90wxGnOjJo

housebg:
Eather neather of you have ever seen the tool I am talking about or they sent me one that is bad it does not come appart.I had one from Jann it worked good,the pne from Di-it does not come apart or maybe it is frozen together I have had some experence with skirt makers not this one i

bryanmc57:

--- Quote from: housebg on 12/27/21 13:45 UTC ---Eather neather of you have ever seen the tool I am talking about or they sent me one that is bad it does not come appart.I had one from Jann it worked good,the pne from Di-it does not come apart or maybe it is frozen together I have had some experence with skirt makers not this one i

--- End quote ---

If it's this one https://store.do-itmolds.com/Skirt-Tool_p_1256.html you just push the bands over the loop and up the barrel.  Then you hook the tabs on the wire hook, pull them into the barrel with the looped end of the wire and slide the band off the tube and onto the skirt tabs.  If it's not that one I don't know what to tell you because that's the tool on the do-it site...

Navigation

[0] Message Index

[#] Next page