Foil hot stamping questions

[Fishermanbt]

This week I received materials to foil some some flutter jigs via hot stamping. I just can’t seem to get the process down to get complete coverage. Anyone that has experience in such care to share your process?
A picture of a few failed attempts.

[ctom]

I use foils from JoAnn's Fabrics that requires no heat. Just brush on the adhesive and allow to dry until clear then carefully lay your foil over the area and press it down with your finger tip. The adhesive is sold right along side the foil. I'll put a picture of the product up here in a minute

[ctom]

Here’s the product picture.



There are 30, 4X6 sheets to a package. While the picture doesn't show it, these foils will look like silver and gold plating when applied. I finish with a dip/drip of CS Seal Coat.

[Fishermanbt]

Yeah I have some of that in gold, silver, and green gold along with the gilding glue. Very user friendly that stuff is. The hot stamping foil is somewhat similar but requires heat and pressure to make the base substrate sticky and to release the foil from the plastic film onto the bait. It also allows for a wide array of holographic patterns that I have not seen with the easy to use foil sheets.

[ctom]

I tinker with the foiling but haven't spent a ton of time with it. Originally I thought it would make a good base to spray transparent paint over but have found the cranks with the holographic film inside will do a much better job. I've foiled quite a few of the baits you show, for others who use them thru the ice.

[Fishermanbt]

I think I might have found my problem. I had originally used a rattle can primer as a base coat. After switching over to a regular rattle can paint this foil sticks like glue after the paint heats up and gets tacky.
Same baits in full light and partial light.

[ctom]

Wow! They look nice! You should show the process.