Custom Baits - Forum

Soft Plastic Bait Making => Soft Plastic and Plastic Baits - How To??? => Topic started by: CNickerson78 on 12/17/17 16:56 UTC

Title: Clean up
Post by: CNickerson78 on 12/17/17 16:56 UTC

How do you all clean you Pyrex cup after use? Do you just wash with soap and water?

Title: Re: Clean up
Post by: ctom on 12/17/17 16:58 UTC

I wipe as much debris as possible out of the cups then wash them in hot soapy water.

Title: Re: Clean up
Post by: CNickerson78 on 12/17/17 17:00 UTC

Quote from: ctom on 12/17/17 16:58 UTC

I wipe as much debris as possible out of the cups then wash them in hot soapy water.

Thank you ctom. I was going to do that but figured I'd as 1st

Title: Re: Clean up
Post by: ctom on 12/17/17 17:57 UTC

I hand dry the cups then let them air dry a while and put each in the microwave for about 10 seconds to get any moisture in the pores of the glass out. Once this is done I just stack them , ready for use.

Title: Re: Clean up
Post by: bryanmc57 on 12/18/17 08:02 UTC

I spray the inside with wd40 then wipe them clean with a paper towel.

Title: Re: Clean up
Post by: MT204 on 12/18/17 10:07 UTC

Paper towel to get the big stuff, paper towel and alcohol then nuke in microwave for a short blast.

Title: Re: Clean up
Post by: 2XL on 12/18/17 11:48 UTC

I do the same thing as MT