Custom Baits - Forum

Jigs, Spinnerbaits and Sinkers => Crappie / Pan Fish Jigs => Topic started by: MADA on 01/09/19 03:40 UTC

Title: My solution for keeping the mold warm
Post by: MADA on 01/09/19 03:40 UTC

Very simple but it works.
And best of all, the materials was for free..

Title: Re: My solution for keeping the mold warm
Post by: ctom on 01/09/19 09:30 UTC

I lay my molds across the top of the pot to keep warm. Very warm I should say.

Title: Re: My solution for keeping the mold warm
Post by: Brent on 01/09/19 10:54 UTC

I have an electric cup warmer that i use, electric skillet for multiple molds, goodwill cheap

Title: Re: My solution for keeping the mold warm
Post by: t-billy on 02/27/19 15:55 UTC

Quote from: ctom on 01/09/19 09:30 UTC

I lay my molds across the top of the pot to keep warm. Very warm I should say.

Same here. Works great. I dip a corner of my bullet bolds into the melt for a couple minutes to get them up to temp. They like to run hotter than my jig molds.

Title: Re: My solution for keeping the mold warm
Post by: WALLEYE WACKER on 02/27/19 23:15 UTC

I also put molds on the melting pot for lead and a skillet for plastic molds and injector until the 5 or 6 th round of bait’s the both stay hot after that. Has anyone that use the large injector notice just how fast aand how long it stays hot after a couple shots because of the volume of plastic it holds.