Custom Baits - Forum

Soft Plastic Bait Making => Articles and Videos => Topic started by: OIR on 02/06/20 17:44 UTC

Title: old parts to new tools (tubes)
Post by: OIR on 02/06/20 17:44 UTC

https://www.youtube.com/watch?v=1TQaXDZWQ-g (https://www.youtube.com/watch?v=1TQaXDZWQ-g)

a easy tool made from old parts or ebay.

Title: Re: old parts to new tools (tubes)
Post by: BobTheBeast007 on 02/06/20 22:02 UTC

Great idea and a good video, I’ll try this when I get into making tubes

Title: Re: old parts to new tools (tubes)
Post by: WALLEYE WACKER on 02/06/20 23:07 UTC

Sweet mold how did the uv glue hold up to the heat of making tubes

Title: Re: old parts to new tools (tubes)
Post by: OIR on 02/07/20 14:08 UTC

only the rods got hot.

wiki:
UV curing adhesives are available in a range of viscosities and several different chemical systems,
most of which are polymer based. These include acrylics, epoxies, polyurethanes, polyesters and silicones.

 It can ignite if it reaches a temperature greater then 93?.
bringing its temperature below -60? may embrittle an adhesive. Tapping of the cold part may shatter the bond

Title: Re: old parts to new tools (tubes)
Post by: WALLEYE WACKER on 02/07/20 16:13 UTC

Thanks for the info OIR

Title: Re: old parts to new tools (tubes)
Post by: Apdriver on 02/07/20 16:14 UTC

That’s a great idea using readily available parts. Thanks for sharing your idea.

Title: Re: old parts to new tools (tubes)
Post by: Les Young on 02/08/20 19:09 UTC

Great idea & video as usual.