Custom Baits - Forum

Soft Plastic Bait Making => Soft Plastic and Plastic Baits - How To??? => Topic started by: floridagrimp on 09/19/12 11:37 UTC

Title: Griddle for large injector? yes it works...but
Post by: floridagrimp on 09/19/12 11:37 UTC

but is there any type of glove, protection you can wear or anything to do to cover large injector so you can holder it longer as it gets waaay too hot?  (aside from buying another injector)  Thanks 

Title: Re: Griddle for large injector? yes it works...but
Post by: 412BaitCo on 09/19/12 11:41 UTC

How hot are you getting the injector? I always wear nitrile gloves over normal cotton gloves and never had an issue?

Title: Re: Griddle for large injector? yes it works...but
Post by: floridagrimp on 09/19/12 12:07 UTC

Nitrile gloves too small for me (great glove though)  that's probably the solution, wear a smaller, thinner glove underneath.   Thanks

Title: Re: Griddle for large injector? yes it works...but
Post by: 412BaitCo on 09/19/12 12:35 UTC

I'm pretty sure you can get nitrile gloves just about anywhere so if jason's don't fit you I'm sure there is somehow local that has them bigger. I have the ones from CCM and love them! so easy to clean up.

Title: Re: Griddle for large injector? yes it works...but
Post by: BareKnuckleJigs on 09/20/12 00:41 UTC

If You're looking for nitrile's, I'd check WallyWorld or any "pharmacy based" store, or hardware stores.  I use a pair of long, leather "welders" gloves, and they're OK, but I do occasionally encounter hot Pyrex cups that I have to put down, strangely.  Like a few facets of my system, this one is also flawed and in need of revision.

Title: Re: Griddle for large injector? yes it works...but
Post by: romeo d on 09/20/12 09:15 UTC

I wrap a small section of my injector with a silicone baking sheet.  Just the area where my hand will rest.  I warm up the surface not covered by this silicone sheet.