Custom Baits - Forum

Soft Plastic Bait Making => Soft Plastic and Plastic Baits - How To??? => Topic started by: chase102798 on 10/25/12 17:37 UTC

Title: flippin' hog laminate problems
Post by: chase102798 on 10/25/12 17:37 UTC

I was trying my laminate plate that I ordered for the flippin hog last night and the first half went fine. When I removed the laminate plate and replaced the factory cavity side and shot the bait, the half plastic I first shot would fall out of the side it was supposed to be in and the plastic just ran all around the first half side in there (does that make sense?). I've been doing alot of laminate carrot sticks with no problems, but I am fairly new to the laminate plates. Any tricks?

Title: Re: flippin' hog laminate problems
Post by: MicroSpoons on 10/25/12 17:45 UTC

inject very slow

Title: Re: flippin' hog laminate problems
Post by: jl3140 on 10/25/12 17:51 UTC

Quote from: MicroSpoons on 10/25/12 17:45 UTC

inject very slow

X2 It helps alot to inject slowly.

Title: Re: flippin' hog laminate problems
Post by: kipbass on 10/25/12 18:36 UTC

I hear a little worm oil in the cavity can help hold it in too.