Author Topic: Griddle for large injector? yes it works...but (Read 3296 times)

floridagrimp · « **on:** 09/19/12 11:37 UTC »

but is there any type of glove, protection you can wear or anything to do to cover large injector so you can holder it longer as it gets waaay too hot? (aside from buying another injector) Thanks

412BaitCo · « **Reply #1 on:** 09/19/12 11:41 UTC »

How hot are you getting the injector? I always wear nitrile gloves over normal cotton gloves and never had an issue?

floridagrimp · « **Reply #2 on:** 09/19/12 12:07 UTC »

Nitrile gloves too small for me (great glove though) that's probably the solution, wear a smaller, thinner glove underneath. Thanks

412BaitCo · « **Reply #3 on:** 09/19/12 12:35 UTC »

I'm pretty sure you can get nitrile gloves just about anywhere so if jason's don't fit you I'm sure there is somehow local that has them bigger. I have the ones from CCM and love them! so easy to clean up.

BareKnuckleJigs · « **Reply #4 on:** 09/20/12 00:41 UTC »

If You're looking for nitrile's, I'd check WallyWorld or any "pharmacy based" store, or hardware stores. I use a pair of long, leather "welders" gloves, and they're OK, but I do occasionally encounter hot Pyrex cups that I have to put down, strangely. Like a few facets of my system, this one is also flawed and in need of revision.

romeo d · « **Reply #5 on:** 09/20/12 09:15 UTC »

I wrap a small section of my injector with a silicone baking sheet. Just the area where my hand will rest. I warm up the surface not covered by this silicone sheet.

Author Topic: Griddle for large injector? yes it works...but (Read 3296 times)

floridagrimp

Griddle for large injector? yes it works...but

412BaitCo

Re: Griddle for large injector? yes it works...but

floridagrimp

Re: Griddle for large injector? yes it works...but

412BaitCo

Re: Griddle for large injector? yes it works...but

BareKnuckleJigs

Re: Griddle for large injector? yes it works...but

romeo d

Re: Griddle for large injector? yes it works...but