ES Beaver Bug woes

[kyflyfisher]

My friend Kevin and I have started molding pladtics.  We are having trouble with the ES Beaver Bud filling out.  The first 2 or 3 injections go fine, then the claws are only about half way filled out.  We have tried shooting a little cooler than 350 but still won't fill out.  Any ideas appreciated.
We gave the ES 5" Senko, 33" Ripper, and 5" Jerkbait and are having no problems with them.

[WALLEYE WACKER]

Try a little worm oil

[efishnc]

I have not used this mold, but when I had troubles with the Ring-it not filling, the key was to get the plastic hotter and inject slower... (you should only need 5 - 10 degrees more, but watch your plastic so you don't scorch).

[Lines]

I agree with WalleyeWacker and efishnc. Brush a little worm oil in both halves of the mold, warm the mold some and shoot with a little hotter plastic. Injecting slowly and holding pressure for a few seconds should help a lot. Here is how I warm my molds and injectors:

Good luck!