mold clamping questions

[mouthsmasherbaits]

i have seen a few molds that dont have to be clamped...they have a couple of line up pins and some screw type fastners that hold the mold together... i have thought that they would be easy to add to a ccm mold. what is yalls thought...

[matt]

you can screw the molds but I like using clamp, you use 2 but I like being safe so I use 4 clamps

[pjmcla]

All around I prefer the CCM method; hinged and clamped.   The only time where a bolt and nut mold is preferred is if I am only injecting a single mold.  The second case does not happen very often.  I typically have at least three molds clamped together but seldom clamp more than four.  If I am injecting five ( or more ) I will break them into groups of three and two, three and three, etc.     

[biglewers]

I have taken all the screw locks out of mine and just clamp them together.  Its faster when shooting multiple molds, of the same size.

[Billmo]

Im with Biglewers, I took all the screws out of mine. the only thing that has a screw in it is my blending block..

[chase102798]

Yeah, the Irwin quick clamps are alot faster than my screw knob molds. I prefer clamps.

[t-billy]

 I prefer clamps as well. I use the Irwin style clamps when shooting multiple molds. If I'm shooting a single mold that shoots easily I just use a couple hinged clamps. They're faster yet.

[biglewers]

x2 on the blending block. 

[wilks19]

We have a few molds that have screws with wing nuts on them.  If I am doing just that mold, I will use the wing nuts and screws if it is for a few lures.  However, I am mass producing now and I have taken them out and I am using clamps.  It is quicker and much easier using the clamps.  Good luck.