Anyones 4.5'' boss hog been shootin funny?

[DobynsTriton]

probably goin to have to refund 3 invoices because nothin is gonna get made form that mold at this point

[BareKnuckleJigs]

The only thing that comes to my mind to try would be how I shoot Ringworm molds...once I put the tip of the injector in the gate/port, I tilt the mold so the vent-end is above the injection-end so as I inject, the plastic is flowing upwards inside the mold (upwards thru the cavity), and inject as slow as You can get away with.  Be extra careful of spills/runs/squirts when doing this, though.

[DobynsTriton]

i wouldnt be able to hold onto everythin . im shootin lams . the single colors would do the same thing

[BareKnuckleJigs]

May try putting something under the vent-end so it's at an angle.

My theory behind this- I believe that, at an angle, the "lower" details in the cavities should fill 1st as the plastic flows, leaving the "upper" details to fill-out secondly which should be successful if those details are vented.  Plastic moving upwards shouldn't (again, in theory) clog vents before the cavity is filled, if the molds' details are given time to process everything.  Complex, numerous, small details like to trap air so we may need to work harder to overcome those air-trapping tendencies.

Why it's now acting up is a head-scratcher.

[DobynsTriton]

the 3.5 newt is pretty much the same body but shoots just fine. its ridiculously odd

[BareKnuckleJigs]

You live North of the Gulf of Mexico a ways, uh?

[DobynsTriton]

close to kentucky lake

[BareKnuckleJigs]

Roger on'nat.  Wish I could help more with this phenomenon, Dob.

Maybe go CTomTastic on it and hand-pour the 1st color (Hail Mary status now).