What is the Total Width of Just The Injector Bodies (Outside Dimension) when this Full Unit is Assembled (not counting the Blending Block)?
The reason I ask is this...I've been Pondering Increasing my "single injector" Capacity, with either a BT 6-ounce or a Do-it 10-ounce Injector, BUT if I can use this Twin to shoot ONE Color (using the entire Assembled Twin) by putting both Injectors into my Pot (to the Bottom, of course), I will then have Increased my Capacity while obtaining a Twin.
This Full Unit looks a bit more narrow than others and hope I can Capitalize on its more-Narrow Outside Width for this Dual Purpose.
Edit - Looks like the Blending Block is the Same Width as the Injectors...!...that would be EVEN BETTER for the Single Color because then I could draw into the Injectors THROUGH the Blending Block, which would eliminate putting the Blending Block onto the Injectors after filling the Injectors AND it would warm the Block.
Is the Block actually the Same Width as the Injectors?
