Author Topic: Nano laminate plate (Read 2136 times)

fsh4fun · « **on:** 11/21/12 09:18 UTC »

OK,so first thing this morning I`m in the man-cave playing with my new nano fry mold and the laminate plate. Using the laminate plate, after the first shot,it looks like I have to remove each bait by hand and than replace them back into the mold one at a time. Thats not so easy getting those little baits back in the right place.Has anybody found an easy way to do this? I was going to try to cut them off the spru,but that might scratch the mold.

Jason · « **Reply #1 on:** 11/21/12 10:01 UTC »

Don't do that... Once you take the lami plate off just lay your fingers across the bodies (making a "V") and pull the spru/runner out like a zipper. All your bodies should stay in place. If not they will only need a slight adjustment. Close the mold and shoot it again (slow). You now have laminated Nanos!

Sorry you had to go through the above experience.

Jason

TheDreamer · « **Reply #2 on:** 11/21/12 10:03 UTC »

Jason nailed it!

I use a bit of worm oil on all my lami plates before I shoot them, this allows the baits to stay in the cavities during the de-mold process.

Hope this helps,

Drew

fsh4fun · « **Reply #3 on:** 11/21/12 10:16 UTC »

Thanks for the info guys,I knew there must be an easier way.Leaving for deer camp in about 1 hr.,back home on Sunday and I`ll try again. Thanks,and happy Thanksgiving to all.

Jason · « **Reply #4 on:** 11/21/12 11:50 UTC »

The fee for free advice is a pound of sausage.

fsh4fun · « **Reply #5 on:** 11/21/12 11:57 UTC »

That can be arranged. Now I just need to shoot a deer!